Mitsubishi EVO 9 Power Test

EVO 9 Performance Part Power Test

EVO 9 Performance Part Power Test – The Mitsubishi EVO is one of the kings the modern automotive tuning industry. Its turbocharged 2litre engine, 4 wheel drive and advanced transmission system make it one of the most capable and exploitable cars money can buy. The tuning market is flooded with performance parts for the EVO 9 some good some not so good. Import Tuner magazine carried out a performance part power test on an EVO 9 MR to see how am XS Engineering Reflash, a HKS EVC VI Boost Controller and an Apexi GT Spec Cat Back Exhaust system effect the power output of this legendary machine.

see also:
EVO Tuning Specs vs Power
EVO Tuning Guide
Mitsubishi EVO History and Specs
Mitsubishi EVO Buying Guide
Mitsubishi EVO VII RS Sprint
Mitsubishi EVO Tuning Specialists
Mitsubishi EVO FQ300 Review
EVO Exhaust Systems
Mazda MX-5 Performance Part Power Test
Mazda RX-7 Performance Part Power Test
Nissan 240SX Performance Part Power Test
Honda S2000 Performance Part Power Test
Rolling Road & Dynos
Japanese Performance Car Part Manufacturers – General

EVO 9 Performance Part Power Test

EVO 9 – Dyno Run 1

Baseline dyno run revealed a healthy 261 bhp @ 7000rpm and 244.7lbs/ft @ 3500rpm at the wheels from its TD05HR-16G6C-10.5T turbo and its 4G63 motor with MIVEC variable valve timing.

EVO 9 – Dyno Run 2

XS Engineering Reflash. Reflashing of the ECU allows the factory engine management to remain in control of the engine while using all the original sensors. This enables all the factory fail safes to remain. The Reflash uses a generic program for EVOs using a cat back exhaust system and an electronic boost controller although XS Engineering recommend taking your car to their premises to get a custom map made up.

EVO 9 Performance Part Power Test

After the Reflash peak power increased to 284.1bhp at the wheels @ 6750rpm and torque was up to 262lbs/ft @ 3500rpm with healthy gains throughout the rpm range.

+17bhp
+18lbs/ft

EVO 9 Dyno Run 2

Apexi GT Spec cat back exhaust system. A fully polished work of art. Seriously though, its said a lot but in this case the exhaust really does look to nice to put in underneath the car. The quality an even of the welding just shows how much time and thought Apexi have put into the design. The GT Spec system has one of the biggest bore pipes on the market at 95mm and one of the biggest tails at 4.5inches. The tail also come with a removable silencer when you want to keep the volume down. The resulting dyno graph show a general smoothing of both the torque and power curves with a resulting peak power output of 292bhp @ 6250rpm and torque up to 267.9lbs/ft @ 3500rpm.

+8bhp
+5lbs/ft

EVO 9 Dyno Run 3

The HKS EVC VI comes from a long line of high quality HKS boost controllers. One of the biggest steps forwards with this new EVC VI is to program desired boost levels at specific RPM and throttle position points. The HKS EVC VI also has the ability to monitor up to two other sensor signals. The resulting dyno graph with the HKS boost controller is an even smoother graph for power and torque. Good gains from 3500rpm upwards with peak power raised to 299.7bhp @ 7000rpm and 270.5lbs/ft @ 3600rpm although peak power increases are largely due to an increase of 1.5 psi in max boost pressure.

+7bhp
+3lbs/ft

Conclusion

Total gains of 32.6bhp & 25.8lbs/ft

Performance Part Costs

XS Reflash 395USD
Apexi GT Spec Cat Back Exhaust 799USD
HKS EVC VI Boost Controller 650USD

 

This page was last modified Aug 8, 2011 @ 8:50 am

Leave a Reply

Your email address will not be published. Required fields are marked *